Fusing Question??

Submitted by cdchilds on Fri, 08/20/2010 - 16:23.

I'm making some fused glass suncatchers for a craftshow.  Check my kiln and for some strange reason some of my dircrohic detail work has popped off a few of the suncatchers.  What would cause this?

I tacked glued them on with thined white glue, they dried and then I placed them in the kiln. 

I'v actually made these suncatcher before and I'm using the same firing as last time.  I had a perfect firing.

Any advise on what may be the cause?

 

Thank you,

CDChilds

 

 

 

‹ Using rubberstamping to transfer designs on glass that is being fused vitrigraph ›

Pam B have you made sure

Submitted by Pam B on Fri, 08/20/2010 - 23:53.

Pam B

have you made sure your kiln is still level?

 

 

Glass Popped Off

Submitted by Paul Tarlow on Sat, 08/21/2010 - 16:10.

Are you saying the glass moved while firing - or that the pieces came apart after the firing was complete?

----------------------
Paul
FusedGlass.Org
Helios Kiln Glass Studio
PaulTarlow.com

 

Fusing question

Submitted by cdchilds on Mon, 08/23/2010 - 00:57.

Hi Pam,

Yes my kiln is level.  I have a paragon GL24 front loading kiln.  I'v had it now for about 5 years.

CDChilds

 

Fusing Question

Submitted by cdchilds on Mon, 08/23/2010 - 01:02.

Hi Paul,

The glass popped off in some areas.  While the actual suncatcher remained in tack.  It was the dichroic detail that popped off around 1089 degrees. 

I took a peek through one of my peep wholes and noticed that a few of the dichroic pieces had popped off and flipped over.  The pieces I'm speaking of are very, very small.  When I realized what had happened I aborted my firing. 

After the kiln cooled I repositioned the pieces and fired again with no problems.  I was just wondering what might have caused this to happen.

Denise

 

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.